Wanhao Duplicator I3 V2 Spool holder

Designed for use on the Wanhao Duplicator I3 V2 and in such a way that no supports are needed. Can be printed in one go on a 200x200 bed but recommend you print the bearing and clamp pins with 100% infill and the rest at 33%. Sliced with Simlify3d V4. You will need to print 4 clamp, 4 bearing pins, 2 lock-nuts and purchase 4 22mm x 8mm x 7mm bearings. I used PLA+ but please note, do NOT over tighten the pins, the shoulder may or may not site flush (depends on your printer settings. Hot end 192,