Anycubic i3 MEGA - Camera mount

A single print camera mount that slips just under the build plate.
I would increase the infill to make it more sturdy. Try 50% or more...
No supports needed. The model should be positioned already, when you load it in to slicer.
I use Cura, so have only tested that. Generally have the model right angle to the fan...so less likely to blow it over.
I have printed 3 so far and all printed OK.

UPDATE: I have 2 i3 Megas. I had only tested it on the new one (December17)
I discovered on m