Thingiverse
Circular cooling Anet A8,Hessine M505
by bob23
2
Downloads
1
Likes
0
Makes
Update March 5:
The fan duct has been modified to center the duct better around the nozzle. I found that on long prints the fan would sag slightly from radiant heat from the hot block. If you printed it in ABS this wouldn't happen, mine was printed in PLA. Version V2 should not have this problem when printed in PLA.
I couldn't find a fan duct that fit my printer perfect so I created my own. I think my Anet A8 is a clone because every duct I tried was off by at least a little from the p
The fan duct has been modified to center the duct better around the nozzle. I found that on long prints the fan would sag slightly from radiant heat from the hot block. If you printed it in ABS this wouldn't happen, mine was printed in PLA. Version V2 should not have this problem when printed in PLA.
I couldn't find a fan duct that fit my printer perfect so I created my own. I think my Anet A8 is a clone because every duct I tried was off by at least a little from the p
Sign in to leave a comment
Sign in