Dirtdevil Platinum Force - Dirty Tank Drain Cap

I print with 100% infill (can be ~50% - 100%, must withstand forces of vacuum suctions)
WITH support (to keep the little lock grooves gap)
0.2mm layer height. (not really important, can be 0.1-0.3)


I design it because ..
of course the original cap fall in the toilet as I dump the tank, and amount of water in tank will cause toilet to flush itself, and cap is gone into the sewer :(

and I will rather make cost of use 13m filament than paying 20$ for replacement and with shipping

e