SnapMaker Filament and Screen Holder

I hate the position of the filament spool holder on the SnapMaker 3d Printer. The filament has to come off the spool at an odd angle and I have already had the spool come unwound twice. This mounts to the top of the Z linear module. In the center hole you place a 20x20mm (or 3/4 inch) piece of square tubing. Then on the side of the square tubing you drill and tap two holes for the spool holder that comes with SnapMaker. There are two spots for M3 nuts and screws on the back side to allow you to