i3 Plus Dual LED Holder (Wanhao, Cocoon Create, Monoprice, Balco etc)

A dual LED strip holder for the i3 family of printers - I specifically designed this for my Cocoon Create Touch (i3 Plus clone). I use the rear mounted Cobra cooler (https://www.thingiverse.com/thing:1090433) so the factory fan mount is not used.

The offset screw pillars ensure the lights are centred on the hotend.

When using a 24V system, wire the 2 strips in series - no resistors needed. For 12V just wire them in parallel.

Some re-wiring/splicing required... I spliced the power from