Anet A8 - Quick Release Fan

This makes filament change a lot easier

I modified the existing plans to accommodate 8mm X 3mm magnets, readily available at Home Depot. I enlarged the counter sink so that you can easily use the spare bolts from your Anet A8 build to attach the fan mount and base mount.

I hot glued the magnets in, but might try super glue, as they can pull out if you pull straight. Slide the fan to the side to prevent magnet from pulling out.

Magents: (8mm X 3mm - listed as 0.3in X 0.11in)
https://w