Thingiverse
FT Sparrow Motor Mount
by cplesca
5
Downloads
3
Likes
0
Makes
A remix of some of FlyMike's designs for use on the FliteTest Sparrow.
The motor mount holds motors with 16mm hole spacing and fits in the 2cm hole that gets covered by the motor mount in the original design. Mine broke off after a crash, plus I wanted to be able to remove the motor.
I'm using it with a A2212 1000KV Brushless Motor.
It uses two skewers to hold in place. For that, I've joined two of his hole savers into one piece since the hole spacing lines up.
The motor mount holds motors with 16mm hole spacing and fits in the 2cm hole that gets covered by the motor mount in the original design. Mine broke off after a crash, plus I wanted to be able to remove the motor.
I'm using it with a A2212 1000KV Brushless Motor.
It uses two skewers to hold in place. For that, I've joined two of his hole savers into one piece since the hole spacing lines up.
Sign in to leave a comment
Sign in