Thingiverse
LED Strip Light Mount for 2020 Extrusion (Folgertech FT-5 R2)
99
Downloads
52
Likes
0
Makes
45 degree waterproof LED strip mount remixed from others.
For FolgerTech FT-5, you will need four 223mm guides for the front and back top rails, four 203mm guides for the left and right rails, and four of the corner guides. Install the corner guides first. Might need to tap them in with a hammer as they are beefier than the long guides.
Optionally, if you want, one 400mm rail for the lower front rail.
The guide rails should be printed vertically in vase (corkscrew) mode with a raft. T
For FolgerTech FT-5, you will need four 223mm guides for the front and back top rails, four 203mm guides for the left and right rails, and four of the corner guides. Install the corner guides first. Might need to tap them in with a hammer as they are beefier than the long guides.
Optionally, if you want, one 400mm rail for the lower front rail.
The guide rails should be printed vertically in vase (corkscrew) mode with a raft. T
Sign in to leave a comment
Sign in