HC300 Assembly Tool (Minimized)

The original Hypercube 300 Assembly Tool does not fit the bed on 200x200 3D Printers so i remixed it by cutting on the sides a little with OpenSCAD. It's width is now 180mm instead of 208mm so that it can easily fit the smaller bed. I also rotated it 90 degrees so if you have smaller Y size because of paper clips it won't collide.

The edges where i cut is a little sharp as i don't know how to make chamfers yet because i am new to OpenSCAD. But it was the easiest way to cut it as i have a pro