Reinforced Spinner for 3Dlabprint Piper Pawnee (Dusty)

Here is my design of a reinforced spinner for the 3Dlabprint Piper Pawnee.

It is only 2g heavier than the original one, but way stronger and it did not fail in the static test (see video).

https://vimeo.com/260546162

There are two versions of the rear part. One is 2mm longer than the ther one. The longer one has the same length like the original spinner.

Print with at least 2 perimeters, 30% infill, layer height 0.2mm.

To attach the front to the rear part, use the screws that come