Thingiverse
PSU 350 W Cover
by Karlosek
68
Downloads
29
Likes
0
Makes
I am building Prusa Bear half upgrade printer from spare parts.
https://www.thingiverse.com/thing:2562174
I had to buy new PSU for that. Unfortunately, I bough higher wattage one, that had bigger case than original Prusa. So I had to design new PSU cover for that. Nothing fancy like the Prusa's but working quite OK.
I have to drill new 4 mm hole in the Z gantry because the original one is not high enough for this bigger case.
Or - there is better solution. If the PSU is supposed to be used
https://www.thingiverse.com/thing:2562174
I had to buy new PSU for that. Unfortunately, I bough higher wattage one, that had bigger case than original Prusa. So I had to design new PSU cover for that. Nothing fancy like the Prusa's but working quite OK.
I have to drill new 4 mm hole in the Z gantry because the original one is not high enough for this bigger case.
Or - there is better solution. If the PSU is supposed to be used
Sign in to leave a comment
Sign in