Thingiverse
Hypercube 2020 Hinged Fan-mount
by Balmung83
22
Downloads
7
Likes
0
Makes
Just a simple hinged fan-mount for the Hypercube.
It might fit all printers where the control-board is mounted in a similar way.
You`ll need two M5x10mm buttonhead screws and hammer nuts to mount it to the frame, two M5x25mm screws and lock nuts for the hinge and two M4x15 screws and nuts to mount the fan.
I'm using a 80mm Noiseblocker Black Silent fan - it is virtually unnoticeable, but has enough power to keep your stepsticks plus a mosfet-module mounted right next to the RAMPS-board nice
It might fit all printers where the control-board is mounted in a similar way.
You`ll need two M5x10mm buttonhead screws and hammer nuts to mount it to the frame, two M5x25mm screws and lock nuts for the hinge and two M4x15 screws and nuts to mount the fan.
I'm using a 80mm Noiseblocker Black Silent fan - it is virtually unnoticeable, but has enough power to keep your stepsticks plus a mosfet-module mounted right next to the RAMPS-board nice
Sign in to leave a comment
Sign in