Thingiverse
Z-Axis lead screw Support
by Wursterland
8
Downloads
8
Likes
0
Makes
Made this Z-Axis support for the bottom end of the lead screw of my FLSUN i3 c 2017.
I modified the Aluminium Z-Motor Plates by drilling the outer hole to 6mm and tapping a M6 tread into both vertical extrusions.
I then mounted the motor plates with a single M6x20mm and 2 M4x10 bolts with hex- or t-nuts.
This increases the rigidness of the printer but moves the motors out by approx. 20mm.
The support takes a standard 608 bearing and is fastened to the lower chassis
with 2 M4x10 bolts wi
I modified the Aluminium Z-Motor Plates by drilling the outer hole to 6mm and tapping a M6 tread into both vertical extrusions.
I then mounted the motor plates with a single M6x20mm and 2 M4x10 bolts with hex- or t-nuts.
This increases the rigidness of the printer but moves the motors out by approx. 20mm.
The support takes a standard 608 bearing and is fastened to the lower chassis
with 2 M4x10 bolts wi
Sign in to leave a comment
Sign in