Yet Another Universal Spool Holder

This spool holder should be able to fit most spools, while allowing for different ways of mounting them. It uses generic 608z bearings, which you will need to force into the screw parts, then proceed with the rod bits into the bearings themselves.

The rods are meant to fit into 6mm (longest radius) hexagons.

## Spool holder

You will need to print:
- male screw 1x (large flat side down, 0.2, 20% infill. no supports)
- female screw 1x (large flat side down, 0.2, 20% infill, no supports)