Cube robot

*Edit: 2018-04-22*: Honestly this should be the last time I change the foot. It's 9.5mm high but I shorted it from the back 0.5mm. Will test out shortly for good fit.

*Edit: 2018-04-18*: Shortened the foot from 10mm to 9mm (from the short edge). I noticed it was just a little too large. I don't think it affects it too much but was just annoying me. I may change it to 9.5mm if the change is too much.

*Edit: 2018-04-03*: Added breakaway supports to the body part so now you can just print it