Thingiverse
Ender 2 Slim Filament Spool Axle
by nanowhisker
40
Downloads
37
Likes
0
Makes
This design was inspired by https://www.thingiverse.com/thing:2746703.
The pitch of the original design thread didn't match the nuts of my Ender 2 so I designed this axle from scratch.
The axle will take spools with a hole diameter down to 20 mm (e.g. Dremel, BioFila, etc.) and a width up to 70 mm.
INSTRUCTIONS:
1. Print the "01_Test-Thread" object to check wether it fits the nuts of your original Ender 2 spool holder. It might be necessary to scale the object in X and Y direction (no
The pitch of the original design thread didn't match the nuts of my Ender 2 so I designed this axle from scratch.
The axle will take spools with a hole diameter down to 20 mm (e.g. Dremel, BioFila, etc.) and a width up to 70 mm.
INSTRUCTIONS:
1. Print the "01_Test-Thread" object to check wether it fits the nuts of your original Ender 2 spool holder. It might be necessary to scale the object in X and Y direction (no
Sign in to leave a comment
Sign in