MeCreator 2 Cyclops/Chimera mount

This is a mount for the Chimera/Cyclops cooling/hotend on the MeCreator 2.
It needs 2x M3 nuts and 2x M3 10mm screws for affix it.

My set from china had large tolerance, so would block due to too little cooling with PLA. Added Copper Grease along the tubes going up in cooling unit. Grub screws are bad. Soft. And pointy. I have replaced 1 with a standard M3 screw.

I think the bed will be higher. You can adjust the endstop on the back of the printer with a 2.5mm hex screwdriver. I have done