Thingiverse
Filament Runout Sensor V2 - for Makerbot/RepRap/Geetech mechanical endstop
by BETLOG
17
Downloads
3
Likes
0
Makes
Filament Runout Sensor - Revisited
Smaller.
No lever on the microswitch; direct button pushing.
Connects to the extruder, so impossible to forget.
- 2018-04-07--12-33-40
I have some poorly wound filament that is intermittently wiggly. This often causes misreading of the runout sensor. I have discontinued using this sensor becasue of this, and will defer to my previous version for now.
ie: if your filament is normal it should work fine. If your filament is highly irregular in diamet
Smaller.
No lever on the microswitch; direct button pushing.
Connects to the extruder, so impossible to forget.
- 2018-04-07--12-33-40
I have some poorly wound filament that is intermittently wiggly. This often causes misreading of the runout sensor. I have discontinued using this sensor becasue of this, and will defer to my previous version for now.
ie: if your filament is normal it should work fine. If your filament is highly irregular in diamet
Sign in to leave a comment
Sign in