Thingiverse
Creality Ender-2 Base Plate
by lewtwo
54
Downloads
24
Likes
0
Makes
Revised 8 April 2018
My problem with the “Y” AXIS turned out to be the location of the “Y” end stop sensor switch. I had it in the top slot of the “Y” AXIS extrusion. It belongs in the bottom slot. It is the back wheel of the carriage that is supposed to trigger the micro-switch. This is a complete rework. My mistake, my ignorance, my apologies.
Moving on ....
I still want to put a larger base on the bottom because my printer sits on top of four vibration
dampening pads to reduce the no
My problem with the “Y” AXIS turned out to be the location of the “Y” end stop sensor switch. I had it in the top slot of the “Y” AXIS extrusion. It belongs in the bottom slot. It is the back wheel of the carriage that is supposed to trigger the micro-switch. This is a complete rework. My mistake, my ignorance, my apologies.
Moving on ....
I still want to put a larger base on the bottom because my printer sits on top of four vibration
dampening pads to reduce the no
Sign in to leave a comment
Sign in