Thingiverse
Hold down bracket with 3mm screw hole for Anet A8
by KoenvdE
11
Downloads
7
Likes
0
Makes
Remix of Anet A8 Hold Down Bracket by freemark
The thing I changed is the diameter of the mounting hole, I changed it to 3.2mm so you can use it with 3mm screws and washer. Also its a little less wide with 12mm.
To mount them just put a layer of isolation tape around the m8 rod and put the bracket on, then just screw it to a wooden sheet with enough thickness or just screw it against the table/workbench. I use 24mm(2x12mm glued together) thick MDF and it's going nowhere.
The thing I changed is the diameter of the mounting hole, I changed it to 3.2mm so you can use it with 3mm screws and washer. Also its a little less wide with 12mm.
To mount them just put a layer of isolation tape around the m8 rod and put the bracket on, then just screw it to a wooden sheet with enough thickness or just screw it against the table/workbench. I use 24mm(2x12mm glued together) thick MDF and it's going nowhere.
Sign in to leave a comment
Sign in