Thingiverse
The Squall - E3D Titan Aero DUAL 5015 blower mount with hidden bltouch mount for CR10 CR10S
127
Downloads
76
Likes
1
Makes
OK, so I was 90% of the way there with the single blower Titan Aero mount, and just thought "meh".
So I went large and did a new thing.
**BLTouch V2.1 + EZABL V1.28 update**
Added extra support under the left fan mount to make printing in the upright orientation (nozzles on the bed) easier with ground up supports only, and added a small support under the right fan mount too. Also removed a lump from the carriage plate to make fitting the heat block in easier when installing.
**EZABL V1.2
So I went large and did a new thing.
**BLTouch V2.1 + EZABL V1.28 update**
Added extra support under the left fan mount to make printing in the upright orientation (nozzles on the bed) easier with ground up supports only, and added a small support under the right fan mount too. Also removed a lump from the carriage plate to make fitting the heat block in easier when installing.
**EZABL V1.2
Sign in to leave a comment
Sign in