EZT T1 Delta Effector for e3D V6 with Part Cooler !Supportfreeprint!

I Build in the Ramps 1.4 and it works OK for me. I use the DRV8825 without a board cooler at Vref 0.5V (Resistor 0.1Ohm)
The Uploaded Repetier comes with configuration for reprap discount smart controller and the Eeprom files my finished config. This can be added over Repetier Host.
If i become the firmware i upload the Marlin for a MKS Sbase 1.3 Board.


UPDATE:
V3:
- Little Changes for better Airflow and print
- Mount it with the 3mm washer at the carrierconnection (not at the effector