Mount for MOSFET-board inside control box Wanhao Di3

I didn't find any mosfet-board holder to my liking so I made my own. This holder sits firm with no additional glue. Printed with red PETG in the picture.
Prints with four M3 threaded holes. Using two screws should be enough. 8mm long.
Make sure to cut your mosfet-to-PSU wires long enough for easy control-box reassembly.

Installation guide:
http://thatnerdchannel.blogspot.se/2017/06/mosfet-upgrade-wanhao-duplicator-i3-v21.html

If this helped you, consider posting a "make" or even tip me