Working Rudder for 3dlab P47, also cleats etc.

I suddenly realised the P47 did not have a steerable rudder ??? So I modified the .stl part using ideamaker 'cut plane' to put a 30degree V front on the rudder section, this allows it to move when hinged. Use CA hinge sheet, burn slots in tail and rudder with hot knife blade then glue in.
Photo shows with supports still on so look at stl to see the V. I modified the tail by removing the locating lugs with ideamaker, then both tail and rudder printed with a bottom thickness of 1.2mm to give s