Thingiverse
Simple Handle v1
by s0h0punk
11
Downloads
6
Likes
0
Makes
A simple handle with 4 3mm holes for screws.
Width is ~150mm
It holds 4kg with ease when printed with 15% infill (I haven't tested anything else).
It's a bit challenging to print because of a load of supports in any orientation.
The center supports also weren't too easy to remove, at least in my case. Some filing had to be done.
After a few failures it seems to print best with the mounting plates attached to the print bed.
Happy Printing!
Width is ~150mm
It holds 4kg with ease when printed with 15% infill (I haven't tested anything else).
It's a bit challenging to print because of a load of supports in any orientation.
The center supports also weren't too easy to remove, at least in my case. Some filing had to be done.
After a few failures it seems to print best with the mounting plates attached to the print bed.
Happy Printing!
Sign in to leave a comment
Sign in