Thingiverse
Anycubic Kossel Linear Plus Magnet Upgrade
by Atziano
425
Downloads
274
Likes
2
Makes
This parts are used to convert an Anycubic Kossel Linear Plus to magnetic delta arms.
These are designed so that the original hotend can be used.
The original geometry of the printer stays nearly the same (rod lengh 267mm).
The magnets I've used are magnetized according to the manufacturer with n40 and have a holding power of about 5 kilograms. But this probably applies to smooth metal surfaces. With the steel ball used, the tightening force will be lower, but enough to keep the effector.
These are designed so that the original hotend can be used.
The original geometry of the printer stays nearly the same (rod lengh 267mm).
The magnets I've used are magnetized according to the manufacturer with n40 and have a holding power of about 5 kilograms. But this probably applies to smooth metal surfaces. With the steel ball used, the tightening force will be lower, but enough to keep the effector.
Sign in to leave a comment
Sign in