Proxxon Router Remix

I have redesigned the top of Danuuc's Dremel Router to allow for the thread of as Proxxon FBS 115/E rotary tool. I printed on the CR10 at 0.2 resolution at 50% infill (20% would be fine i just wanted the extra strength.)
I used two M6x100mm Carriage Bolts which i secured in place with epoxy resin. I had to widen the holes on the underside of the base using a scalpel to allow for my size of bolts, but this wasn't much of an issue.

Original Dremel Model by Danuuc

https://www.thingiverse.com