Thingiverse
Tripod Adapter 1/4" to 5/8" for Laser Level etc
by makerbot40
67
Downloads
46
Likes
1
Makes
I made this adapter for putting a Laser Level 5/8" thread on a regular 1/4" photo tripod.
The design is in openscad and you can adjust the base cylinder to suit (shown as r=15mm).
The 1/4" thread is a bit tight so may have to run a test print OR adjust the tolerance value in openscad to suit your 3D printer.
Requires Library from https://www.thingiverse.com/thing:965737
Nuts and Bolts v1.95 OpenSCAD library.
I have included in upload.
You can also modify this to use for Pro consumer
The design is in openscad and you can adjust the base cylinder to suit (shown as r=15mm).
The 1/4" thread is a bit tight so may have to run a test print OR adjust the tolerance value in openscad to suit your 3D printer.
Requires Library from https://www.thingiverse.com/thing:965737
Nuts and Bolts v1.95 OpenSCAD library.
I have included in upload.
You can also modify this to use for Pro consumer
Sign in to leave a comment
Sign in