Thingiverse
3 Blade Spinner Nut Cap (M5)
by Opteryx
15
Downloads
12
Likes
0
Makes
*UPDATED 10/22/2018*
Spinner Nut Caps (Tested with HQProp 5x5x3 & RaceKraft 5046 props)
I suggest using either a high quality PLA or ABS, print with 100% infill.
Print with the spinner tip facing bed. Best results have been achieved using a brim/skirt touching the part with 8 outlines, 1 layer tall.
Use thick CA glue around the opening for the M5 nut and push into place.
You will want to use a motor wrench and a small Allen key to tighten/loosen the nut/spinner assembly.
T
Spinner Nut Caps (Tested with HQProp 5x5x3 & RaceKraft 5046 props)
I suggest using either a high quality PLA or ABS, print with 100% infill.
Print with the spinner tip facing bed. Best results have been achieved using a brim/skirt touching the part with 8 outlines, 1 layer tall.
Use thick CA glue around the opening for the M5 nut and push into place.
You will want to use a motor wrench and a small Allen key to tighten/loosen the nut/spinner assembly.
T
Sign in to leave a comment
Sign in