Thingiverse
Angled Dry Box Feeder
by YasiekPL
93
Downloads
66
Likes
0
Makes
filament feeder for samla box.
WARNING:
on the photo it is on the top of the box, better way is mount it on the side (every time when I open the box, I un-spool filament - when you move feeder to side, you can open and close lid freely).
WARNING2:
Remember, hole in the lid have to be angled too, just after made a hole push dril to a proper side.
Parts are little to tight - for mout without glue or screws (you can drill a bit, but then use a glue to mount). evetually you can add screw
WARNING:
on the photo it is on the top of the box, better way is mount it on the side (every time when I open the box, I un-spool filament - when you move feeder to side, you can open and close lid freely).
WARNING2:
Remember, hole in the lid have to be angled too, just after made a hole push dril to a proper side.
Parts are little to tight - for mout without glue or screws (you can drill a bit, but then use a glue to mount). evetually you can add screw
Sign in to leave a comment
Sign in