Back
water holder for Janoel 12 Incubator – 3D printable model from Thingiverse Thingiverse

water holder for Janoel 12 Incubator

3 Downloads
6 Likes
0 Makes
Download Model
This container holds water to increase the humidity in the Janoel 12 incubator by about 15-20%. There are holes in the bottom of the divider allowing water to flow freely between the sides. With the lid on one side, the container only needs to be refilled every other day.

Just adding water to the bottom of the incubator raised my humidity too much, so I wanted a smaller container that would hold water and only have to be refilled every other day.

Instructions: Fill the container with wa
Source
Thingiverse
Comments
0

Bewertung

Noch keine Bewertungen

Comments

No comments yet – be the first!
All Thingiverse Models More by happykatten

Similar Models

6 Suggestions

Add to Collection