Clamp for NEMA 17 Stepper Motor

UPDATE: I added a 1.5 mm thick version (original clamp is 3.0 mm thick). The 1.5 mm clamp is very light, and extremely flexible even when printed with PLA.

Although there are other uses, I used this for a quick, non-permanent way to keep the X carriage wires from dragging along the edge of the printer and pulling down the carriage.

The clamp is:
• 10 mm wide.
• 0.2 mm layer height.
• 100 pct infill.

I printed this using PLA. The clamp is thin enough to flex and slip aroun