Thingiverse
Flyingbear P902 Carriage reference
7
Downloads
4
Likes
0
Makes
Intended for reference!
This is a model I made of the carriage on my flying bear P902 for the purpose of making sure parts that I design to work with it will fit.
Notes:
The two 3mm holes on the side represent an M3-0.5 Tapped hole.
If you use this please take into account where the belt will attach, its about 6mm from the wide side of the opening on mine. It also passes under that point. I've included models with it's approximate position to make this a bit easier.
This is a model I made of the carriage on my flying bear P902 for the purpose of making sure parts that I design to work with it will fit.
Notes:
The two 3mm holes on the side represent an M3-0.5 Tapped hole.
If you use this please take into account where the belt will attach, its about 6mm from the wide side of the opening on mine. It also passes under that point. I've included models with it's approximate position to make this a bit easier.
Sign in to leave a comment
Sign in