XCarve CNC PCB Holder/Base (V2)

Designed to fit on the X-Carve from Inventables. Allow to fix or hold a PCB blank to the waste board for precision carving. I don't know the specs of other CNC waste boards, but will fit any with hole spacing of 75mm (2.95" inches).

Made to fit blanks from Inventables (152.4mm x 152.4mm) - [6" x 6"].

This is a printed/tested part (will upload photos soon). Tolerances are tight to help on fitting on dual side prints.

**Blanks:**
https://www.inventables.com/technologies/circuit-board-bl