Bondtech Feeder NEMA 17 Cetus3d MKII

I'd gotten fed up with the terrible feeding section of the Cetus MKII. I created this to convert to the 5mm Bondtech Feeder Drive setup. This particular conversion is for any 42mm Nema17 motor (I used the 17HS4401 in my case). Check my other things for the same conversion specific to the Cetus MKII extruder servo (Moons Servos).


V1.1 Moved idler out to add 0.1mm backlash. Not enough torque with this servo to push through the filament when it's at 0 backlash. Also moved the "access hol