Thingiverse
CR 10 Direct Drive Extruder Mod Single Part
by Unified_3D
111
Downloads
52
Likes
1
Makes
CR 10 Direct Drive Extruder Mod Single Part, remixed from another 2 part design.
The Extruder is still not centered over the print head but it's a lot closer than the version this was remixed from.
Watch the dual fan setup on the far side of the x-axis I haven't tested it yet but I did make a provision for what I assume will be tight clearance.
The Extruder is still not centered over the print head but it's a lot closer than the version this was remixed from.
Watch the dual fan setup on the far side of the x-axis I haven't tested it yet but I did make a provision for what I assume will be tight clearance.
Sign in to leave a comment
Sign in