2Pin connector substitution sleeve

A sleeve , substitute for 2 pin connector.
Excellent fit for JST-XH 2pin (XHP-2) or equiv.
(used as fans/sensors/etc. connector in most of PCBs I know)
I made this for Anycubic Trigorilla's fan port.

housing: 5.0 x 7.3 mm
contact hole: 2.5 x 3.3 mm x2 ( with this large hole, you can use many type of contact tip.

Wall thickness is just 0.4mm, so this must be printed with "Thin wall option".　

Attention
This is just "Sleeve", focused on insulation.
There are no lock between housing