Ikea Lack End Table Logitech C270 Webcam Mount

This is a little bracket to hold your Logitech C270 webcam.

It clips on fairly securely with no hardware, but has accommodations for 3mm screws to tighten it down.

The camera fits in fairly snug without hardware, but it has an accommodation for a 3mm screw.

I printed it in PETG. I regret that. I will reprint in PLA as PETG tends to creep over time and loosen its grip.

It doesn't hold the camera up high enough to see the build platform if attached to the platform your printer is sitt