CR10 C270 Webcam Mount for a 15mm sleeve

This is a remix of the C270 mount by dpetsel. I really liked the design of this, stays clear of the bed and gantry, attaches natively to the C270, and built in cable management.

I removed the screw mount (wasn't needed) and made the top hole big enough to accommodate some 15mm washers I'm using as solid bed mounts.

I printed at 50% infill, 3 perimeters and 3 layers top and bottom, but it's probably overkill to be honest.

If you print it laying on it's side (with the cable management cha