Thingiverse
chimera+ mount for cr-10 with 5015 blower hotend cooler
by hipsel
17
Downloads
9
Likes
0
Makes
I am designing a chimera+ mount for my creality cr-10.
My attempt is to design a mount which does not reduce the print volume (and prints with minimal support with my old, one extruder only, setup). Probably 1-2cm z-hight is lost, but at least x and y should be presumed, for BOTH nozzles.
Furthermore the leveling screws at the side of the heatsink must not to be blocked.
I want to use a 5015 blower, as they have higher air pressure than fans, but I also designed a version with a 40mm fan:
My attempt is to design a mount which does not reduce the print volume (and prints with minimal support with my old, one extruder only, setup). Probably 1-2cm z-hight is lost, but at least x and y should be presumed, for BOTH nozzles.
Furthermore the leveling screws at the side of the heatsink must not to be blocked.
I want to use a 5015 blower, as they have higher air pressure than fans, but I also designed a version with a 40mm fan:
Sign in to leave a comment
Sign in