Thingiverse
TronXY X5s Mosfet Holder
by JD_Printing
47
Downloads
35
Likes
0
Makes
This is my version of 24 Volt heatbed upgrade for the TronXY X5s.
The cover is snap-fit to the base. 12 V cooling fan (just in case).
It works great! Even after insulating the underside of the bed it use to take 30 minutes to get up to 65 C. After a test run to see if it would work - how about 5 minutes to 69C.
*** Important note; Set the 24 Volt supply output to 21 Volt. Otherwise the maximum power output from the power supply could be exceeded. (This limits the output to around a
The cover is snap-fit to the base. 12 V cooling fan (just in case).
It works great! Even after insulating the underside of the bed it use to take 30 minutes to get up to 65 C. After a test run to see if it would work - how about 5 minutes to 69C.
*** Important note; Set the 24 Volt supply output to 21 Volt. Otherwise the maximum power output from the power supply could be exceeded. (This limits the output to around a
Sign in to leave a comment
Sign in