Thingiverse
28mm Modular Bar
door Curufin
12.3k
Downloads
6.4k
Likes
17
Makes
NORM!
All models are designed to print flat and without supports or rafts. All files have been run though NetFabb. I printed these in PLA at a resolution of .1mm.
I found a good deal of inspiration from Talismancer's bar: http://www.thingiverse.com/thing:1194408
Each individual section of the bar has 3 files. A Bottom, a Top, and a Front. The parts with a 1, 2 or 3 indicate a straight section of either 1", 2", or 3" in length. Parts with a 22.5 or 45 indicate the angled sections, 22.5 degrees or 45 degrees. Part with a R, L, or C indicate either Right side, Left side, or Center sections. A part with 'RL' means it can be used for either the right side or left side.
Enjoy!
All models are designed to print flat and without supports or rafts. All files have been run though NetFabb. I printed these in PLA at a resolution of .1mm.
I found a good deal of inspiration from Talismancer's bar: http://www.thingiverse.com/thing:1194408
Each individual section of the bar has 3 files. A Bottom, a Top, and a Front. The parts with a 1, 2 or 3 indicate a straight section of either 1", 2", or 3" in length. Parts with a 22.5 or 45 indicate the angled sections, 22.5 degrees or 45 degrees. Part with a R, L, or C indicate either Right side, Left side, or Center sections. A part with 'RL' means it can be used for either the right side or left side.
Enjoy!
Curufin publiceert ook op
86 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
