28mm trees - remix

Remix of tree 1 and 3 from the great source. I've added some holes at the bottom for 4mm x 1mm magnets if required but could add different sizes if needed. Will probably add a proper base at some point too.

Tree 1: Slightly smaller with a re-sculptured lower area and a tweak to remove possible supports higher up. A bit wobbly so better sticking to a base.

Tree3: Slightly smaller and modified with a re-sculptured lower part to remove all the spacing

Note, I've run out of foliage so haven't had a change to add any yet. These are straight off the printer and base coated ready for some.