Thingiverse

WD40 straw

by Mahoganut

86 Downloads

49 Likes

0 Makes

Download Model

pipe straw tube WD-40 wd-40 straw wd40 wd40 straw pipe straw tube WD-40 wd-40 straw wd40 wd40 straw

This printed quite well on my Flashforge Finder but it did need a little sanding to fit my WD40 can. I think this is due to the entry/exit points during the print, as the straw is so small it appears slightly misshapen. I had it in my can after about 20 seconds of sanding.

I had no need for a long straw but you can make it longer in your slicer if you require.

Speed: 50mm/s
Infill: 100%
Layer Height: 0.08mm

Source

Thingiverse

Comments