Thingiverse
Battery Tray for Align 550
by Cassan
2
Downloads
3
Likes
0
Makes
This is a battery tray for the Align 550 R/C model helicopter.
It's at least as good as the supplied one!
I printed 5 on Ultimaker 3 using CPE. Most were perfect.
Two I needed to sandpaper a little off so that they slide
in and our easily.
High res (0.1) is best for the smoother operation of the latch.
Solid is best - it's still lighter than the original, though less stiff too.
It's at least as good as the supplied one!
I printed 5 on Ultimaker 3 using CPE. Most were perfect.
Two I needed to sandpaper a little off so that they slide
in and our easily.
High res (0.1) is best for the smoother operation of the latch.
Solid is best - it's still lighter than the original, though less stiff too.
Sign in to leave a comment
Sign in