Thingiverse
Vertical fan duct from 40mm to 60mm for Anycubic Kossel linear plus
by ykatchou
20
Downloads
18
Likes
0
Makes
I wanted to have my printer very silent, so after changing my driver to the famous TMC2208, i was annoyed by the noisy extruder blower. So i did change it from the default 40*40*10mm fan to a 60*60*20mm fan, buuuut the rods were blocked by the new fan :(.
So i design this duct fan in order to mount it properly and without blocking the rods.
It does fit well and the noise level is very good.
It's still a bit noisier than the 60mm without the duct (which block the rods), but still very very s
So i design this duct fan in order to mount it properly and without blocking the rods.
It does fit well and the noise level is very good.
It's still a bit noisier than the 60mm without the duct (which block the rods), but still very very s
Sign in to leave a comment
Sign in