Rear Frame support for Tevo Tornado

Full credits to C3N for his original design this is based on :

I needed one side of the frame to be on the aft side of the Printer to give my printhead with petsfang some room. So I took C3N's original design and created the parts to fit on the rear side of the printer. I have now one on the front (C3N's original desgin), and one on the back (this design).

Same as the original from C3N you need :
2 M8 rods
8 M8 nuts
8 M5 x 20mm Screws
8 M5 x 10 x 6 T-Nuts (like the ones that came with