SUP Lamp

This is a lamp based on the design of a real SUP-board.

If you only want to have the board itself you need to print SUP, SUP_Fin and SUP_Plug.
If you want to use it as a lamp you need everything but the plug used to seal the end.

Note the height of approximate 33cm, which is too much for most small printers.

I used M3x6mm screws to screw in the bottom plate und used a cheap 5V LED-stripe to illuminate the board from below.

Look at https://www.thingiverse.com/thing:2965219 for a pad