Thingiverse
Bed Level Tuning Kit (Prusa & Clones)
by mgx
168
Downloads
99
Likes
0
Makes
This is a kit for leveling the bed of Prusa MK2/MK3 and similar when the bed warp is too severe for the automatic calibration to handle it properly.
The included tweezers is an absolute time saver, in fact I found it next to impossible to squeeze the stack of washers+spacer under the MK3 bed which is full of magnets.
How to use: you add a couple M3 **spring** washers under the bed spacers (more where needed but keep in mind each washer is 0.5-0.8mm). You then measure and adjust as needed
The included tweezers is an absolute time saver, in fact I found it next to impossible to squeeze the stack of washers+spacer under the MK3 bed which is full of magnets.
How to use: you add a couple M3 **spring** washers under the bed spacers (more where needed but keep in mind each washer is 0.5-0.8mm). You then measure and adjust as needed
Sign in to leave a comment
Sign in